Previous | Toc | Next |
throttle body assembly. Parts to be discarded are marked with an asterisk (*). Replacement should be made from the Master Repair Kit.
ORDER OF REMOVAL / PART NAME | |
1. |
Fuel Inlet Plug |
2. |
Fuel Inlet Plug Gasket* |
3. |
Pump Link Pin Retainer* |
4. |
Pump Link Pin* |
5. |
Pump Link Retainer* |
6. |
Pump Link* |
7. |
(2) Throttle Body to Main Body Screws |
and Lockwashers | |
8. |
Throttle Body to Main Body Spacer |
9. |
Accelerating Pump Rod Felt Seal* and (2) |
Washers | |
10. |
Accelerating Pump Rod Felt Seal and |
Washer Spring | |
11. |
Throttle Body to Main Body Gasket* |
(a) The disassembly of the main body assembly from the throttle body assembly differs
Figure 2. Dissassembly-Main Body
from the procedure given in the Service Manual as follows. After removing the fuel plug and gasket (Step 1), remove the pump link pin retainer and slip out the pump link pin. Discard the pump link pin retainer. Refer to the Service Manual for the balance of the disassembly procedure (Steps 3 through 5).
C. DISASSEMBLY - MAIN BODY
The following list contains all parts removed in disassembling the main body assembly. Parts to be discarded are marked with an asterisk (*). Replacement should be made from the Master Repair Kit.
ORDER OF REMOVAL / PART NAME | |
1. |
Secondary Venturi Clamp Screw and |
Lockwasher | |
2. |
Secondary Venturi Clamp |
3. |
(2) Secondary Venturi Tubes |
4. |
Fuel Inlet Fitting |
5. |
(2) Fuel Inlet Fitting Gaskets* |
6. |
Secondary Tube Bracket |
7. |
Fuel Inlet Fitting Seal* |
8. |
Air Cleaner Anchor Screw |
9. |
Bleeder Screen Washer and (2) |
Lockwashers | |
10. |
(4) Main Body Cover Screws and |
Lockwashers | |
11. |
Main Body Cover |
12. |
Main Body Cover Gasket* |
13. |
(2) Secondary Jet Head Nuts |
14. |
(2) Secondary Jets and Gaskets |
15. |
Accelerating Pump Return Spring |
16. |
Accelerating Pump Operating Rod |
17. |
Accelerating Pump Spring |
18. |
Accelerating Pump Spring Washer |
19. |
Accelerating Pump Piston Assembly* |
20. |
(3) Economizer Body Clamp Screws and |
Lockwashers | |
21. |
Economizer Body Clamp |
22. |
Economizer Diaphragm and Stem |
Assembly* | |
23. |
(2) Idle Tubes* |
24. |
(2) Main Well Tubes* |
25. |
Pump Discharge Needle* |
26. |
Fuel Inlet Needle Seat* |
27. |
Fuel Inlet Needle Seat Gasket* |
28. |
Float Shaft* |
29. |
Float Assembly |
30. |
Fuel Inlet Needle and Clip |
31. |
Float Spring* |
-10
Previous | Toc | Next |